Märklin mSD Ljuddekoder för Ellok 8-pins NEM med kabel

Märklin mSD Ljuddekoder för Ellok 8-pins NEM med kabel, stödjer mfx, MM1, MM2 och DCC, förprogrammerat ljud för ellok.

This decoder is for converting Märklin/Trix H0 locomotives with built-in high-efficiency motors or other DC motors. The märklin mSD SoundDecoder has a wiring harness soldered to it. This wiring harness has an eight-pin NEM connector plug for converting many locomotives with a corresponding NEM connector and locomotives without much space. The märklin mSD SoundDecoder supports the digital formats mfx, MM 1, MM2, and DCC. The decoder has preset sound for an electric locomotive.

Conversion Decoder:
Decoder with extensive sound functions and with a wiring harness
1 auxiliary function on the hardware (+2 instead of a motor also possible)
60965 for steam locomotive
60966 for diesel locomotive
60967 for electric locomotive

Common Features:
Can be used for all Trixand Märklin H0 Locomotives!

Protocols:
MM2
MFX
DCC
Analog AC
Analog DC

Motor:
Monitoring
Sine
As function outputs

Mapping using:
MFX
DCC

Braking Module:
Märklin
DCC

Speed Levels:
14 (DCC, MM2)
27 (MM2)
28 (DCC)
128 (DCC, MFX)

Operating Mode Outputs:
Dimmer (for dimming)
Flash 1
Flash 2
Strobe (1 light flashing)
Double Strobe (2 lights flashing)
Random
Smoke
Zoom
Mars
Gyrating Lights
Neon
Energy Save
Software for Telex

Analog Functions:
Acceleration and braking delay can be adjusted.
You can set which auxiliary functions are to be active.
Load compensation monitoring is active.

Functions:
Auxiliary outputs can have a maximum load of 250 milliamps(limited only by the total maximum load for the decoder).
Switching range control.

Settings:
The mLDand mSDcan be programmed with all Märklin central units (6021 to 60215). On the 6021 programming can be done up to and including CV 80 (system design).
Full programming can also be done with the current Mobile Station.
The mLDand mSDsupport all DCC programming modes including POM(main track programming).

Operational Safety:
A false operational bit is supported so that locomotives from an analog area can enter a digital area without going into reverse.
The fastest possible startup after an interruption in operation (thanks to memory storage of the last settings for a locomotives decoder).

Ease of Operation:
The mLDand mSDare protected against short circuits and overloads.
The mLDand mSDcan be updated.
* Not on mSD with wiring harness
** 1 auxiliary function on mSD with wiring harness

Märklin Sommarnyhet 2011.